Future of AMVs - Most important technology since Lens Flare

Epical Zamora · Post by **Epical Zamora** » Wed Jan 09, 2008 1:48 am

That's simply astonishing. Zephyr is right though, unless it can export the wireframe by itself, it's very limited. But nonetheless, infinitely helpful for anything non-commercial... like us.

Me and Lock go way back, right buddy? ...right? Maybe?

Bauzi · Post by **Bauzi** » Wed Jan 09, 2008 9:01 am

So the 3 hours I spent on a rotoscope would be much more easier with this one. Damn I´m pissed that I didn´t payed attention on this thread much earlier.

bobbias · Post by **bobbias** » Mon Jan 14, 2008 12:54 am

Yeah, If that thing could export a 3D model out, you could take it, clean it up and tweak it, and use that in a fraction of the time that it would normally take to create a model.

post-it · Post by **post-it** » Mon Jan 14, 2008 1:54 am

... That saves a lot of time; compared how I'm doing it now ^^

Epical Zamora · Post by **Epical Zamora** » Mon Jan 14, 2008 4:29 pm

This still needs to use a video rotating around an image though right? Does the rate of rotation factor in at all?

post-it · Post by **post-it** » Tue Jan 15, 2008 4:22 am

.. I'm a little curious about the "light level" for Edge-Detection!??